www.ikancorp.com | 1.713.272.8822 | [email protected]
because we’re
filmmakers
too
Getting Started
Thank you for buying the Stryder IP54 LED Fresnel Spotlight from Ikan. Please carefully read the instructions and guide before operating the products.
The guide includes product usage and maintenance. When you operate the product, please make sure that you have read the instructions carefully. All the
content of the manual is based on up-to-date information; technical data subject to change without notice.
Safety Instructions
1. Connect the power supply to the SW-IP100 Light before plugging into the power source.
2. This light is rated IP54 meaning the fixture is protected against ingress of dust, and water splashed against it from all directions. It is not waterproof.
Please do not submerge the light in water.
3. Don’t drag cables with excessive force. Any repairs on the products should be performed by Ikan technicians. Users should not remove the power
supply, or else the damage will not be covered under warranty.
4. Confirm that the power is off before connecting and changing the fixture head or disconnecting your cable from the power source. We recommend
using Ikan connecting cables and connectors to avoid electrical shock.
5. The voltage shouldn’t exceed the value in the technical specifications. If the voltage is greater than, or less than the regulated values, it could damage
the product.
Operating Instructions
1. Ensure power is off before installation.
2. Place the light on the light stand, release the tension knob on the 5/8” receiver, adjust the light in the desired direction, and then tighten the tension
knob on the 5/8” receiver.
3. When connecting the power cords, plug either the included power adapter or V-Mount battery adapter to 3-pin XLR power connection port (as shown
below).
Control Knob
3-pin XLR
Power Connection
On / Off Switch
