Imported by iiglo, Østre Kullerød 4,
N-3241 Sandefjord, Norway
Made in China | www.iiglo.com
Instruksjonsmanual for: IIDE234W
20
Troubleshooting
Caution! Before troubleshooting, disconnect the power supply. Only a qualifed electrican of competent person must
do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Possible cause
Solution
Appliance does not work
Mains plug is not plugged in or is
loose
Insert mains plug.
Fuse has blown or is defective
Check fuse, replace if necessary.
Socket is defective
Mains malfunctions are to be
corrected by an electrican.
Appliance freezes or cools too
much.
Temperature is set too cold or the
appliance runs at SUPER modes.
Turn the temperature regulator to
warmer setting temporarily.
The food is not frozen enough.
Temperature is not properly
adjusted.
Please look in the initial
temperature setting section.
Door was open for an exrended
period.
Open the door only as long as
necessary.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
Turn the temperature regulation too
a colder setting temporarily.
The appliance is near a heat source.
Please look in the installation
location section.
Heavy build up of frost on the door
seal.
Door seal is not air tight.
Carefully warm the leaking sections
of the door seal with a hair dryer (on
a cool setting). At the same time
shape the warmed door seal by
hand such that it sits correctly.
Unusual noises
Appliance is not level.
Re-adjust the feet.
The appliance is touching the wall or
other objects.
Move the appliance slightly.
A component, e.g. a pipe, on the
reat of the appliance is touching
another part of the appliance or the
wall.
If necessary, carefullt bend the
component out of the way.
Side panels are hot
It’s norma. heat exchange is in the
side panels.
Take gloves to touch side panels if
need.
If the malfunction shows again, contact the service center.
These data are necessary to help you quickly and correctly. Write the necessary data here, refer to the rating plate.