Ihse 483 Series, Руководство пользователя

Страница: 46 / 85

Operation Draco vario DisplayPort 1.1
46
8 Operation
8.1 Downloading the EDID
In the delivery state, the factory-set EDID in the CPU Unit is reported to the source. If these are not the optimal
settings for the console monitor, the EDID can be loaded from the console monitor and stored in the internal memory
of the CPU Unit.
On extender modules with USB HID ports, you can load the EDID of the console monitor via keyboard command
under operating conditions.
1. Enter the Hot Key to start the command mode (see chapter 5.1, page 35).
The Caps Lock and Scroll Lock LEDs on the keyboard are flashing.
2. Press a to load the EDID of the console monitor into the CPU Unit.
The screen will go black for a short time and the LEDs of the CPU Unit and CON Unit flash briefly.
At the same time the command mode is closed, and the keyboard LEDs return to previous status.
3. Restart the corresponding source.
The video mode has been readjusted. Screen quality should be optimal. The source should now show the
console monitor as the current screen, together with the available video resolutions.
If the EDID was loaded once, the EDID can be reloaded by repeating the process.
Keyboard commands are fixed to the position of the keys on the keyboard. Keyboard mapping tables may vary for
country-specific layouts.
E.g., press Hot Key + q on a French keyboard layout (AZERTY) instead of Hot Key + a to download the EDID of
the monitor connected to the CON Unit into the CPU Unit.
8.2 Switching between KVM and local Input
CON Units with local input have the possibility to connect a local source. These extender modules allow an active
manual switching between the extender module connection and the local source.
When using the local KVM switch function, the add-on module L474-BXH is necessary to get USB HID access to the
local source.
The following keyboard commands are available for switching at the following devices:
Keyboard command Function
Hot Key, k, 1, Enter Switch to the extender module connection 1.
Hot Key, l, Enter Switch to the local source.
* For switching of redundant CON Units, see chapter 8.4, page 47.