Draco vario
DisplayPort
1.1
Operation
47
8.3 Switching of Video Channels in Dual-Head Mode
CPU Units offer the possibility for a specific switching of single video channels in Dual-Head mode regarding the
device compatibility and the following requirements:
•
The Dual-Head CPU Unit is connected to a Dual-Head source.
•
An active connection exists between the Dual-Head CPU Unit and the Single-Head CON Unit, either point-to-
point or through a matrix*
•
Identical connection speed (1G/3G).*
* In compliance with the compatibility requirements, see chapter 4.2.1, page 15 and chapter 4.2.2, page 15.
Switching of single video channels is executed by using the following keyboard commands at the CON Unit:
Keyboard command
Function
Hot Key, d, 1, Enter
Switch to video channel 1 of the Dual-Head CPU Unit.
Hot Key, d, 2, Enter
Switch to video channel 2 of the Dual-Head CPU Unit.
8.4 Switching of two different CPU Units via redundant CON Unit
CON Units with a redundant port for interconnect cables offer the possibility to connect two different CPU Units with
different sources.
To switch a redundant CON Unit with two different CPU Units, proceed as follows:
Keyboard command
Function
Hot Key, k, 1, Enter
Switch to the extender module connection 1.
Hot Key, k, 2, Enter
Switch to the extender module connection 2.
Point-to-point connection
With extender modules connected directly, the switching of redundant CON Units to extender module
connection 2 is not available for keyboards connected to add-on modules with USB HID interface.
Matrix connection
With extender modules connected via a matrix, the switching of redundant CON Units to extender module
connection 2 is also available for keyboards connected to add-on modules with USB HID interface.
