5
Using the iP87
Using the Line-in Jack
You can play any iPod without a docking port or other MP3 player or portable audio device through the iP87 via the Line-in Jack.
1. Plug one end of a standard audio patch cord (not included) into the headphone or line-out jack on your device and the other end of
the patch cord into the iP87 Line-in Jack located on the back of the unit.
2. Press the
Radio Button
until “Aux” appears in the lower part of the display.
3. Turn on and play your device.
4. Turn the
Volume Wheel
to adjust the system volume.
5. Press the
EQ Button
to select and turn the
Set Wheel
to set Treble, Bass,3D Sound on/off and Left/Right Balance.
6. To turn off the unit, press the
Button
. Please remember to turn off your device, too.
Sleep Operation
Sleep mode lets you sleep to your iPhone/Pod or radio, gradually lowering the volume until the unit shuts off at the selected time.
1. Press the
Sleep Button
to enter sleep mode. The sleep time will show in the lower display.
2. Press the
Sleep Button
again as needed to adjust the sleep timer from 120, 90, 60, 30 or 15 minutes.
3. When the display changes back to show the real time, press the
Sleep Button
once to show the sleep time remaining. Pressing it
again will change sleep time to next lowest increment.
4. iP87 has independent volume setting for sleep mode so you can adjust the sleeping volume without affecting the normal volume. The
sleep volume will remain at that level the next time you enter sleep mode until controls are changed.
5. To stop listening at any time, press the
Button
to turn unit off.
Dimmer Operation
During normal operation, press the
Snooze/Dimmer Button
to control the brightness of the LCD display.
Using the iP87 in Other Countries
Different regions of the world use different FM radio frequency steps and ranges. You will need to select the one that matches the standards
in your region (USA, UK, EUROPE, JAPAN, AUSTRA,or CHINA).
1. Make sure the iP87 is OFF (not playing in nay mode). Press and hold the
Radio Button
for about 5 seconds until “USA” or other
region appears in the lower part of display. Turn the
Set Wheel
to select your region.
2. Press the
Radio Button
again (or no button within 5 seconds) to exit the radio frequency setting mode.
Install/Replace Backup Battery
The iP87 uses a backup battery system to provide continuous alarm operation and clock settings in the
event of a power failure. If the Battery Low Icon located on the right of the display is flashing, it is time
to replace the backup batteries. Please make sure the AC adaptor is connected, otherwise all settings
may be lost during battery replacement.
Open the battery compartment cover located on the bottom of the unit. Insert 2 “AA” batteries as indicated.
We recommend the use of alkaline batteries for longer life
.
Replacing iP87 Backup Batteries
Battery Warning
For models that require more than one battery
• Do not mix with used or other battery types/brands
• Replace all batteries at the same time
• Do not open batteries
• Do not dispose of in fire
• Do not heat above 75ºC (167ºF)
• Do not expose contents to water
• Do not charge or recharge
• Do not install backwards
