The iP11 Home System for iPhone/iPod features “Sure Alarm”. If a power failure occurs or the AC adaptor is accidentally
disconnected, the unit will change to buzzer alarm to wake you up (provided you have installed backup battery).
This unit also features Gentle Waking, which gradually increases the volume of whatever alarm you set.
NOTE: TO WAKE TO iPhone/iPod, YOUR iPhone/iPod MUST BE PROPERLY DOCKED AND OFF (NOT IN PLAY
MODE) OR NO ALARM WILL SOUND. You CANNOT wake to Line in audio devices.
Setting the Alarm Time
1. Press and hold the
Alarm Set Button
for 2 seconds until the display flashes. Press the
Hour Set Button
until the
desired alarm hour is displayed. Next, press the
Sleep/Minute Set Button
to set the desired alarm minute.
Remember to set the correct AM or PM if you are using 12 hour clock format.
2. Press the
Alarm Set Button
again to exit the setting mode. You should hear 2 beeps indicating the alarm is set.
Note:
Once you set the alarm time, the alarm will be automatically armed, indicated by the
Alarm Icon
. To disarm the alarm,
press the
Alarm Set Button
. The Alarm Icon will disappear and the alarm will not sound at the set time.
Note:
Make sure to adjust volume level for comfortable wake up volume
4. When the alarm is sounding, the
Alarm Icon
will flash.
• To snooze during the alarm, press the
Snooze/Dimmer Button
. The alarm will be silenced for 9 minutes, then come
on again.
• To turn the alarm off, press the
Alarm Reset/Power Off Button
. The alarm will come on again the next day at the
same time.
5. If the alarm is not turned off after it sounds, it will play for approximately one hour then turn off automatically. This cycle
will repeat every 24 hours unless the controls are changed.
Note:
Please make sure your iPhone/iPod has enough songs to play for one hour, otherwise please set the iPhone/iPod
repeat mode to ON.
Note:
If there is no iPhone/iPod present or there is no music detected on the iPhone/iPod at alarm time, the iP11 will
automatically switch to buzzer alarm.
6
Alarm Operation
