Playing Audio via Aux-in
1. Un dock (or pause/stop) any currently docked device. Connect a standard 3.5 mm stereo
audio plug to the headphone or line-out jack on your audio device and the other end to the
Aux-in jack located on the back of the unit.
2. Press and hold the
Button
for about 2 seconds to turn on the unit.
3. Turn on your audio device and place it in play mode.
4. Press and release the
Mode Button
to toggle the unit between iPod/Aux-in audio mode
and Bluetooth mode (the
Button
is NOT lit in iPod/Aux-in mode).
5. Use the
/
- Buttons
to adjust volume. You may wish to adjust the volume on your
audio device, too.
6. When done listening, press and release the
Button
to turn the unit off. Remember to turn
off your audio device, too.
Playing your iPad, iPhone or iPod
1. Make sure the unit has a power source (4 AA batteries are installed or AC adaptor is
connected). Power output (volume) will be lower when operating on batteries.
2. Press the
Dock Release Button
on the back of the unit to expose the flexible 30 pin
connector (if dock is retracted).
3. Gently dock a playing iPad, iPhone or iPod. The unit will power on indicated by the power
light turning blue and in a moment, you will hear the audio from your device.
4. If the volume on your sound source is too low, the unit may not detect it/turn on. If this
happens, press the
Button
to turn the unit on.
5. Control your iPad, iPhone or iPod music using its iPod controls.
Use the
/
– Buttons
on the unit to adjust system volume.
6. When you are done listening, press the
Button
to turn unit off.
P7
4
