IHI Shibaura G-EXE22-OMEGA-C11, Руководство оператора, Страница: 85 / 106

Add a mark
Newspaper
Brush
Marked with chalk
5. Insert a newspaper strip between the blades and the lower
blade, and use the "blade alignment tool" to turn the blades
from top to bottom and test the cutting sharpness. Use
chalk to mark the position where the cutting sharpness is
best.
6. Add the wrapping compound to a brush and then apply it
evenly to the top of the blades at the position you marked
in step 5. Press the switch on the wrapping machine in the
normal rotation direction, to rotate the blades in the clock-
wise direction (reverse of the normal cutting direction).
!
Compound is applied to the cutting areas so that the un-
even edge caused by wearing is straightened.
!
Friction between the blades and the lower blade polishes
the blades.
!
If wrapping is performed while the blades and lower blade
are tightly joined together, the ends of the cutter will be
worn and normal wrapping will not be possible. Do not join
the blades firmly.
7. Gradually apply the polishing fluid to areas where cutting
was not good (areas not marked in step 5), and repeat the
polishing work.
8. After the blades have been polished evenly, add a final
even application of wrapping compound to the blades while
rotating the blades in the clockwise direction (reverse of
the normal cutting direction) to finish polishing.
9. After polishing is finished, wash the blades and lower
blade thoroughly with water to remove the polishing agent.
!
Follow the procedure in "Adjusting cutting sharpness" on
page 26 to adjust the gap between the blades and lower
blade while testing the cutting sharpness.
Important
!
Do not use a high-pressure water sprayer to
wash the mower. It may cause the labels to
peel off or the mower to be damaged.
Adjustments
31