2 – 12
OPERATION
2-4 STARTING ENGINE
Once the pre-start inspection has been completed, the engine
may be started.
Starting at Normal Temperature
If the the engine does not start after 15
seconds, return the key to
OFF
and wait for 15
seconds before returning it to
START
.
1. Move Control shut-off lever to the
LOCKED
position.
2. Move all Controls to the
HOLD
position.
3. Move the engine throttle lever above the low to
medium position (advance about one-third to one-
half).
4. Insert key
c
into the switch and turn the switch
to the
ON
position.
5. Turn the switch to the
START
position.
Do not crank the engine for more than 15
seconds.
Allow the starter to cool for seconds before
cranking again.
6. Release the switch key after the engine starts.
7. Move the engine throttle lever to position
LOW
to
allow the engine to warm.
Starting In Cold Weather
This engine has an inlet manifold heater for cold
weather starting. Do not use other types of
starting aids such as ether. Such use could
result in an explosion and personal injury.
1. Repeat steps 1 through 4 in Stating At Normal
Temperature.
2. Hold the switch in the
HEAT
position to preheat
the engine intake air. After approximately 4
seconds the heater indicator on the monitor will
turn off.
This indicates that the engine is ready to start.
3. Repeat steps 5 through 7 in Stating At Normal
Temperature.
CAUTION
WARNING
Stop
(OFF)
Operation
(ON)
Preheat
(HEAT)
Start
(START)
Heater indicator
Engine throttle lever
Start switch
