IHI Shibaura Fi6000, Инструкция по эксплуатации

Страница: 15 / 36

(13)
5. For longer dry running.
Storing the cooling water in cylinder allows the dry running with idling condition for several
minutes. If you want to operate in this way, leave the water when draining water after the
operation while keeping the cylinder drain cock closed.
Furthermore, when operating in this way during the cold season, make sure to put the
antifreeze into the cylinder. (→P.22 “ Point to be careful about in cold season).
6. Safekeeping
(1) Make the water discharge valve “half open” and then
open each drain cock of water discharge valve, pump
cover, cylinder and muffler part. Push the button of water
stop valve drain to drain completely. After draining,
make sure to close them.
(2) After removing the suction hose, restart the engine. After
operating the vacuum pump for 2-3 seconds to remove
the water in the vacuum pump, stop the engine again.
(3) Install water inlet cap and cover the pump for
safekeeping.
(Notice)
(1) Incomplete draining may cause damage or corrosion by freezing.
(2) In case of using the muddy water or ocean water, rinse out impurities in the pump with
pure water. After that, make sure to drain water in each part.
(3) Keep the pump housing free from moisture.
(4) Make water discharge operation at high speed of throttle dial for 5-10 minutes once a
month.
(5) During the safekeeping, keep on charging of electricity with accessory automatic
battery charger. (→ P.21 “How to handle battery and charger”)
(6) Make sure the water has been drained completely before the safekeeping.
During the cold season, put the antifreeze into the pump.
(→ p.22 “Point to be careful about in cold season).
Open
Open
Open
Open
Open
Open
Half Open
Close
Close
Close
Close
Close
Close