iHerz iTop, Руководство пользователя, Страница: 13 / 22

13
EN
Delete Memories
If you did not get the correct measurement, you can delete all
results by following steps below.
1. Hold pressing “MEM” for 3 seconds when the monitor is in the
memory recall mode ,the flash display will show.
2. Press “SET” to confirm deleting and the monitor will turn off.
3. If you don’t want to delete the records, press “START/STOP” to
escape.
4. If there is no record, the right display will show.
ERROR MESSAGES/ TROUBLESHOOTING
This section includes a list of error messages and frequently asked questions for prob-
lems you may encounter with your blood pressure monitor. If the products not operating
as you think it should, check here before arranging for servicing.
PROBLEM SYMPTOM CHECK THIS REMEDY
No power
Display will not
light up.
Batteries are exhausted. Replace with new
batteries
Batteries are inserted
incorrectly.
Insert the batteries correctly
Low batteries
Display is dim
or show
Batteries are low. Replace with new
batteries
Error message
E 01 shows The cuff is too tight or too
loose.
Readjust the cuff ,not too
loose or too tight and then
measure again.
E 02 shows The monitor detected
motion,talking or the
pluse is too poor while
measuring.
Relax for a moment and then
measure again.
E 03 shows The measurement process
does not detect the pulse
signal.
Loosen the clothing on the
arm and then measure again
E 04 shows The treatment of the
measurement failed.
Relax for a moment and then
measure again.
EExx,shows on
the display.
A calibration error
occurred.
Retake the measurement. If
the problem persists, contact
the retailer or our customer
service department for further
assistance.Refer to the war-
ranty for contact information
and return