Ignition Gawan 200, Руководство пользователя

Страница: 17 / 40

CAUTION!
Risk of injury due to movements of the device
The head of the device can move quickly (pan, tilt) and can produce
very bright light. This is also valid immediately after you turn on the
device, when the device operates in automatic mode or under remote
control and when you turn off a DMX controller that is connected to the
device. Persons staying near the device could be injured or frightened.
Before you turn on the device and during the operation, always ensure
that nobody stays close to the device. If work has to be performed in the
area of movement or in the near vicinity of the device, it must remain
turned off.
4. Confirm your selection with [ENTER] .
ð
The device immediately performs a self test. The selected channel is dis‐
played. The following functions are tested: Pan, Tilt, Color, Gobos, Gobo
rotation, Prism, Prism rotation, Frost, Zoom, Focus, and Dimmer.
5. To end the self test and exit the menu, press [MENU] , or wait 30 seconds.
The device returns to its original DMX state after the self test. The test
values are saved automatically when the device is switched off.
1. Open the main menu.
2.
Navigate to ‘Information’ .
3. Use [UP] and [DOWN] to select the ‘Fixture Use Hour’ , ‘Temperature’ , ‘Fan
State’ , ‘Firmware Version’ or ‘RDM UID’ submenu.
4. Confirm your selection with [ENTER] .
ð
Depending on your selection, the operating hours, the device tempera‐
ture, the fan status, the firmware version or the RDM UI is displayed.
5.
To exit the menu, press [MENU] , or wait 30 seconds.
1. Open the main menu.
2.
Navigate to ‘Information
è
LED Use Hour’ .
3.
Use [UP] and [DOWN] to select the ‘Total LED Hour’ (total time) or ‘LED On
Hour’ (current switch-on time) submenu.
4.
Confirm your selection with [ENTER] .
ð
The desired selection is saved.
5.
Use [UP] and [DOWN] to select the ‘LED Hours Reset’ submenu.
6. Confirm your selection with [ENTER] .
7.
If you wish to reset the relevant LED operating hours, select ‘Yes’ . If you do not
wish to reset anything, select ‘No’ .
8.
Confirm your selection with [ENTER] .
ð
A three-digit PIN is displayed.
Displaying device information
Displaying and resetting LED informa‐
tion
Operating
Gawan 200
17
Moving Head