– 1 –
Q ui c k St a r t G u i d e
1. Unpack and Check Contents
GL-O-1GE-1C-XX
*
Outdoor
GE to G.hn Coax Bridge AP
12 VDC Power Supply
QSG will be posted to the Web
Wall Mounting Screw Kit
2. Mount the Bridge AP
a. Mounting on a Pole
Place the unit against the pole (diameter 20-200 mm).
Use up to 12 mm (1/2 in) strapping to secure the unit to the
pole.
b. Mounting on a Wall
In the required location, mark and drill three holes in the wall
for M4 wall anchors.
2
1
1
2
2
1
1
Note:
For a wood wall, drilling holes and using wall anchors
is not required.
Mount the unit on the wall and secure it in place using the
included three M4 x20 tapping screws.
3. Connect Power
The bridge AP can receive power from one of three different power
sources:
◆
The supplied DC power adapter to the DC power jack.
◆
An external DC power source to its DC In/Out terminal block
◆
Power over Coaxial cable (PoC) to the F-type coaxial connector
(from another Ignite GLinq only)
a. DC Power Jack
Plug the DC power supply into a suitable power mains
outlet.
Insert the DC power supply DIN connector into the bridge
APs DC power jack.
Note:
When power is supplied to the DC jack and the DC
switch is set to ON, the F-type coaxial connector functions as
a 12 VDC PoC power source.
2
2
1
2
Gigabit Ethernet to Coax bridge
GLinq GL-O-1GE-1C
www.ignitenet.com
