– 3 –
Quick Start Guide
Note:
The number of available 2.4 GHz or 5 GHz external antenna connectors
depends on the specific model.
3. Connect Cables
Connect outdoor-rated Ethernet cable to the 1000BASE-T RJ-45 ETH0 (PoE) port on
the unit.
4. Connect Power
Install the PoE power injector indoors. Connect the power injector to the Ethernet
cable from the AP, to a port on a local LAN switch, and then to an AC power source.
Caution:
The power injector module is designed for indoor use only. Never mount
the power injector outside with the AP unit.
Attach External Antennas
Remove the front port cover by
pushing the locking tab up and then
sliding the cover off.
Connect external antennas to the
AP’s 5 GHz RP-SMA connectors using
RF coaxial cable provided in the
antenna package.
Connect external antennas to the
AP’s 2.4 GHz RP-SMA connectors
using RF coaxial cable provided in the
antenna package.
1
2
3
2
3
1
Connect outdoor-rated Category 5e
or better cable to the left-side RJ-45
ETH0 (PoE) port.
(Optional) Connect a local LAN
switch or computer to the right-side
ETH1 100BASE-TX RJ-45 port.
Pass the cables through the access
holes at the bottom of the AP.
Replace the port cover on the AP and
push the locking tab down to secure
it in place.
1
2
3
4
4
3
2
1
