IGM LAGUNA Revo 1836, Руководство по эксплуатации

Страница: 8 / 20

-8- www.igmtools.com
Tail stock knob
Pic. 36
Tail stock handle
Pic. 37
6.2 Cleaning the machine
Remove the rust protection grease with
benzine or a similar solvent. It is important that
you remove all the grease and re-lubricate
with a Teflon-based lubricant. (Teflon has a
lower tendency to attract sawdust and cause
clogging).
6.3 Fitting the rotating centre
Ensure that the bore of the tail stock is clean.
The rotating centre has a number 2 Morse
Taper that fits into the tail stock. Push the
centre into the tail stock bore firmly, and ensure
that it is securely located. To remove the centre,
rotate the adjusting handle until it is as far back
as possible and this will eject the centre.
Pic. 38
6.4 Fitting the drive centre into head stock
To remove the face plate from the head stock
spindle, insert the removal tool into the hole in
the face plate large diameter. Lock the spindle
with the lathe spindle lock and unlock the face
plate by rotating it. Take care not to drop the
faceplate onto the bed of the lathe.
Note: The face plate has a left-hand thread.
Removal tool
Pic. 39
described procedure, seek professional
assistance. Fit the 4 levelling feet to the lathe
legs with the lock nut on the underside of the
leg. Once both legs have been fitted turn the
assembly up to the correct position.
Pic. 29
Pic. 30
Assemble the head stock, tool rest and tail
stock back onto the bed of the lathe and fit
the stops
.
Note
: If you have any doubt about
the described procedure, seek professional
assistance. Do not attempt any procedure that
you feel is unsafe, or that you do not have the
physical capability of achieving.
Assembled lathe
Pic. 31
If you decide to fit the tool rest after fitting the
tail stock, follow the below procedure.
Fit the tool rest onto the bed of the lathe
ensuring that the washer recess fits into the
slot in the bed. Fit the banjo onto the bed with
the bolt through the washer and assemble
the nut onto the thread. Adjust the nut so
that the clamp handle locks the banjo with
approximately 30 degree of movement.
Tool rest disassembled
Pic. 32
Pic. 33
Washer assembled in position
Pic. 34
Pic. 35
Fitting the stock knob
Screw the tail stock knob onto the tail stock
handle.
washer
Tool rest clamp handle
Banjo
clamp
handle
Rotating centre
Adjusting
handle
Levelling foot