IGM Laguna PFlux3Tv2, Руководство по эксплуатации

Страница: 9 / 18

-9- www.igmtools.com
Step 23. Attach the two ends of the Octagon foot pedal to the nut on the
foot pedal bar.
Step 24. Secure the topping to the nut on the foot peddle bar using (1)
M8*30mm hex bolt. Follow this step on the opposite side.
Step 25. Secure the movable supporting brace on the foot peddle bar with
the octagon foot peddle using (2) 3/8”*21mm hex bolts. Make sure the bolt
head is on the inside of the octagon foot peddle. Adjust the tightness of
this bolt accordingly. If this bolt is too tight, the Octagon foot peddle will not
work smoothly. When too loose it will not pick up the Octagon drum.
Step 26. Secure the movable supporting brace on the foot peddle bar with
the octagon foot peddle using (2) 3/8”*21mm hex bolts. Make sure the bolt
head is on the inside of the octagon foot peddle. Adjust the tightness of
this bolt accordingly. If this bolt is too tight, the Octagon foot peddle will not
work smoothly. When too loose it will not pick up the Octagon drum.
Step 27. Apply foam tape to the cone flange before attaching the drum lid.
Secure the Octagon drum lid to the cyclone funnel using (6) 5/16” x 3/4”
hex bolts, (12) 5/16” x 1” flat washers and (6) 5/16” hex nuts. Make sure to
first attach all the bolts before tightening. NOTE: The lid will turn when the
bolts have not been tightened for alignment. Failure to do will result in the
drum lid not being able to align with the drum.
Step 28. Attach the full drum detection sensor to the opening on the drum
lid located behind the cyclone funnel. When securing the sensor make
sure the end of the sensor is not longer then the drum lid rim. If it extends
longer passed the rim, the detection will not function correctly.
Step 29. Attach the LED light to the drum lid using (6) M4*10mm Philip HD
Bolt, (6) 3/16” flat washers and (6) M4 hex nuts.
Step 30. Attach the crossbar to the drum lid and tighten using the two
bolts removed in the previous step. It does not matter which position you
attach the crossbar.
Step 31. Assemble the Octagon drum. Locate the drum base panel, (it
does not matter which side faces inside), and secure the (4) casters using
(16) 5/16” x 3/4” hex bolts, (32) 5/16” x 1” flat washers and (16) 5/16” hex
nuts.