IGM LAGUNA PFlux3Tv2 2022, Руководство по эксплуатации

Страница: 10 / 18

-10- www.igmtools.com
Step 33. Apply foam tape to the cone flange before attaching the drum lid.
Secure the Octagon drum lid to the cyclone funnel using (6) 5/16” x 3/4”
hex bolts, (12) 5/16” x 1” flat washers and (6) 5/16” hex nuts. Make sure to
first attach all the bolts before tightening. NOTE: The lid will turn when the
bolts have not been tightened for alignment. Failure to do will result in the
drum lid not being able to align with the drum.
Step 34. Attach the full drum detection sensor to the opening on the drum
lid located behind the cyclone funnel. When securing the sensor make
sure the end of the sensor is not longer then the drum lid rim. If it extends
longer passed the rim, the detection will not function correctly.
Step 35. Attach the LED light to the drum lid using (6) M4*10mm Philip HD
Bolt, (6) 3/16” flat washers and (6) M4 hex nuts.
Step 36. Attach the crossbar to the drum lid and tighten using the two
bolts removed in the previous step. It does not matter which position you
attach the crossbar.
Step 37. Assemble the Octagon drum. Locate the drum base panel, (it
does not matter which side faces inside), and secure the (4) casters using
(16) 5/16” x 3/4” hex bolts, (32) 5/16” x 1” flat washers and (16) 5/16” hex
nuts.
Step 38. Attach the handles to the top and bottom end on the front panel
with the window display using (4) flat head Philip bolt, (4) 5/16” x 7/8” flat
washers and (4) 5/16” hex nuts. Note that the head of the Philip bolt must
be inserted from the handle with the hex nut and washer on the inside of
the drum.
Step 39. Take the Octagon drum front and back panels and assemble
together by securing with (12) M4 x 12mm sheet metal screws.
Step 40. One the left and right side you will find three bolt holes. Take the
matching side plate and secure to the outside of the panel using (6) 1/4” x
1/2” carriage bolts, (6) 1/4” x 1” flat washers and (6) 1/4” hex nuts. Insert
the head of the carriage bolt from the inside of the drum with the washers
and nuts on the outside of the drum.
Step 41. Lay the drum on its side with the handle facing top. With the help
of another person, hold the base panel with wheels up against the base of
the drum. Using (22) M4 Sheet metal screws to secure tightly.