IGM LAGUNA 2436, Руководство по эксплуатации

Страница: 10 / 22

-10- www.igmtools.com
Note. The headstock can only be controlled by
one controller and you must select which
controller is used by selecting with the
controller selection switch.
6.8 High / low speed
The lathe has two sets of pulleys for high
(135 - 3500 rpm) and low (50 - 1300 rpm)
speed ranges.
Adjust between the speed ranges as follows.
1. Disconnect the electric supply to the lathe.
2. Open the pulley cover.
3. Loosen the motor lock handle and lift the
motor to the highest position with the motor
adjustment handle, then lock the motor lock
handle.
4. Move the drive belt to the required set of
pulleys.
High / low speed
5. Loosen the motor lock handle and with the
motor adjustment handle tension the drive belt,
then lock the motor lock handle. The belt should
be tensioned so that there is approximately 3-6
mm deflection when pressed.
6.9 Indexing the spindle
The spindle has 3 sets of indexing holes 14 / 36
/ 48. The selection plunger is located at the
end of the head stock. To move between the 3
sets of holes, loosen the clamp knobs and
slide the indexing plunger assembly to align
with the selected hole set. Clamp in position
with the clamp knobs. Try the plunger in a
few different holes to check that it inserts and
removes smoothly.
The indexing plunger is spring loaded and this
is used only to temporarily align the plunger
in the selected hole. To fix the plunger in
a selected hole, it must be attached to the
housing by screwing into the clamped position.
There is a hole selection indicator that allows
you to view which hole in a selected hole set
has been selected.
7. Maintenance
General
Keep your machine clean. At the end of each
day, clean the machine. Wood contains
moisture, and if sawdust or wood chips are not
Pulley
cover
Pulleys and drive belt
Motor lock handle
Motor adjustment
handle
indexing
holes
Clamping
knobs
Hole selection
indicator
Hole
selection
Indexing
plunger
Indexing plunger
engaged
Indexing plunger
disengaged