-5-
www.igmtools.com
Operating instructions EN
- Put the protection cover onto the edgebander ( Fig 11) and begin the operation (Fig 12).
Fig. 11
Fig. 12
- The position of magnet chip can be adjusted according to different shapes & sizes of the work pieces. Applicable
for work pieces spinning above the stationary working table by only attaching to the magnet chips. (Fig 13).
Fig. 13
- Swing cutting blade (Optional accessories) (Fig 14) could easily cut the tape while working on edgebanding.
Fig. 14
- The Stationary Worktable can be used with our Edgeband Trimmer, making edgeband trimming a simple task
when paired with our magnet spacers.
- Put the trimmer adaptor plate into the table and tighten it onto the table surface by the set screws (see Fig
15)ollow the direction shown in the figure putting the power trimmer into the fixing rack; put the three screws
through the trimmer rack and tightened into the three screw holes as shown by the arrows in (Fig 16).
- Turn off the power switch before operating the trimmer. Plug the trimmer power-plug into the embedded
trimmer outlet on the working table (see Fig 17). If an emergency condition occurs, press the red emergency
button to shut down the power immediately.
