-3-
www.igmtools.com
Operating instructions EN
Item Name
Purpose
1
Trimmer plate
Use to attached with the edge trimmer onto the worktable
2
Worktable stands
Supporting stands for the worktable
3
Main switch
Magnetic on/off switch, automatically power off when experiencing power failure.
4
Pinning sheets
Place on top of the cruiser case for easy transportation.
5
Stands Storage
Worktable stands can be easily store into the notch
6
Cable Storage
Can be easily store the cable into cable notch
7
Embedded Outlets
Outlet for plug-in tools
8
Fixture Cover
May be use to place on top of the gluepot to prevent high temperature
hazard during operation
9
Positioning magnet chip May be placed onto the worktable to raise or lower the working height of a workpiece.
10
Vacuum handles
May be attached onto the workpieces, use to enhance grip and handling with the
workpieces during operation.
11
Dispenser center roller
Use to stabilize the center of the edgeband or edge tape
12
Edgeband Dispenser
Edgeband or edge tape roll can be placed directly on the dispenser
13
Swing cutting blade
Allows precise cuts that prevents damage to the edgeband
Important Notes
While meeting any emergency circumstance, be sure to turn off power supply and unplug the power-supply plug first.
This working table doesn’t guarantee for all working materials; user shall follow the actual work conditions to
regularly clean up the table surface; once the table surface is stain-polluted, we suggest using the stain-cleanup
detergent to wipe it up; prohibit scratching off the dirt/residual-melt from the table surface directly that would
deteriorate the vacuum clamp effort/capacity in consequence.
The magnet chip must be used together with stationary working table. According to the frequency of usage, clean
the table regularly
Avoid operating this product in a room with high humidity or under raining outdoor space.
Keep this Operation Manual in a safe place in the event that replacement parts are required. Maintain regular
maintenance on this product.
Prohibit plugging any other electric equipment at the table-plugged receptacle that might cause power overload.
Install this working table on a flat and firm table and tighten the table up by the screws attached.
Be noted by the safety label while operating the trimmer. Keep your hands off the blade that might hurt you.
Place manual with worktable.
OPERATION PROCEDURE
- After assembling the worktable stands, drill four holes compliant with the stand positioning holes and fasten
the screws onto the stands. (Fig 1)
- Fasten the supporting stand to the supporting arm(Fig2). Do not leave the supporting leg unsettled. (Fig 3 - Fig 5)°
Fig. 1
