4
3.USING YOUR REFRIGERATOR
1
.
The first time you turn the unit on, set the temperature
control to the “7” position.
2
.
The settings for the temperature control are “0,1,2,3,4,5,6,7”. After 20 minutes, adjust the temperature control
setting to “4”. The setting of “4” should be sufficient for home or office use.
3.
To stop the cooling cycle, turn the temperature control to “0”.
Temperature Control
NOTE: Turning the temperature control to the “0” position stops the cooling cycle, but does not shut off the
power to the refrigerator.
If the unit is unplugged, turned off, or if power to the unit is lost, you must wait 5 minutes before restarting the
unit. If you attempt to restart before this time, the refrigerator may not start.
Store this appliance in the coolest area of the room. This can help save energy. If the room's temperature is too
high, the temperature in the refrigerator may not reach the target temperature.
7
2
1
0
4
6
5
3
THERMOSTAT
CONTROL DIAL
4
.
Precautions
Water getting into the refrigerator may form a layer of frost inside the unit. If the frost is more than
2mm thick, you should defrost the unit.
Defrosting is done manually. When defrosting, set the knob of the temperature regulator to position
“0” (where the compressor will stop cycling) and leave the door open until ice and frost dissolve
thoroughly. To speed up defrosting, you may put a bowl of warm water (about 50°C) into the unit.
After defrosting, be sure to re-set the temperature control knob to the original position.
Do not use hot water or hair dryer while defrosting. Use of these items may cause deformation of the
inner case of the unit.
Do not scrape ice, frost, or food with sharp tools. This may damage the inner casing or the surface of
the unit.
If the power cord of this appliance is damaged, it must only be replaced by a professional or a repair
shop suggested by the manufacturer.
Never allow children to operate, play with, or crawl inside the appliance.
