![background image](http://html1.mh-extra.com/html/igenix/ig6550/ig6550_instructions-for-use-manual_3920601006.webp)
- 6 -
Operating Instructions
1. Make sure the inlet and drain hoses are correctly and securely connected.
2. Press the door release button to open the door.
3. Check to make sure that the filter is in the right position.
4. Place the dishes on the dish rack and cutlery inside the cutlery basket.
5. Check to make sure that the rotating spray arm can turn freely all the way round. If necessary
remove any obstacles.
6. Fill the detergent in the recessed area on inner door panel. 12 grams could be added approximately
for a normal cycle. For pre-wash cycle you should not add detergent.
7. Close the door until you hear a ‘click’ sound.
8. Open the water supply.
9. Press the Power (On/Off) button.
10. The Power Indicator light will illuminate.
11. Select the desired program by press the program button. The program indicator light will light on.
P1 = Intensive Wash
P2 = Normal Wash
P3 = Rapid Wash
P4 = 3 in 1 Wash
P5 = Rinse
12. The appliance will run about 3 seconds later and the program light will flash during all the cycle.
13. At the end of the cycle the dishwasher will stop, the program light will stop flashing and the
dishwasher will beep for several seconds, then the light will go out .The power light will not be off
until the power (On/Off) button is switched off. The dishwasher is designed to stop if the door is
opened accidentally during the washing cycle.
14. You may select another program during operation by pressing the Program Start/Reset button and
hold for 3 seconds to cancel the program current program. Then press the Program button to the
desired program.
15. After washing, dishes should be allowed to cool down for about 15 minutes so that they are not too
hot to handle. Dishes will cool quicker if the door is opened slightly
16. After unloading the dishwasher, remove the filter, clean off any bits of food, and put the filter back in
its position.
Delay Start
You can delay the start of the washing cycle for up to 24 hours. One press of the ‘Delay Start’ button will
delay the start for 1 hour.
IMPORTANT
Do not open the door when dishwasher is running. The door could be allowed to open after pressing the
pause button.
At the beginning of each cycle, the dishwasher always starts in the “drain” mode. This is because the drain
pump always retains a small amount of water (in the sump) from the previous cycle. This is necessary to
keep the pump primed. Therefore, do not be alarmed if you see a small amount of water being pumped-out
from the drain hose prior to the start of the regular wash cycle.
For the drain system to operate properly, the highest
distance between the drain hose and the base of the
dishwasher should not exceed 15 cm (6 inches).
The free end of drain hose must not be in water
w
a
s
te
p
ip
e