9
SELECT THE STEAM
The quantity of steam is regulated by the variable steam selector.
1. Move the steam selector to a position between minimum and
maximum depending on the quantity of steam required and the
temperature selected.
Warning: the iron gives off steam continuously only if you hold the
iron horizontally. You can stop the continuous steam by placing the iron
in a vertical position or by moving the steam selector to minimum/off.
As indicated on the temperature control dial and in the Preparations
table, you can only use steam at the highest temperature if the selected
temperature is too low, water may drip onto the plate
SHOT OF STEAM AND VERTICAL STEAMING
1. Press the steam-shot button to generate a powerful burst of
steam that can penetrate the fabrics and smooth the most
difficult and tough creases. Wait for a few seconds before
pressing again.
2. By pressing the steam-shot button at intervals you can also iron
vertically (curtains, hung garments, etc.).
For the best result, there should be 5 seconds rest between each
press of the steam button. To prevent leaking water from the
soleplate does not press the steam button for more than 5 seconds
continuously. Also allow the iron to rest for 1 minute before using
this function.
Warning: the steam-shot function can only be used at high
temperatures. Stop the emission when the temperature control light
comes on, then start ironing again only after the light has gone off.