2 / 4
P/N 1073041-EN • REV C • ISS 17JUN21
3. Log in to the console. After the terminal has been
connected to the device, power on the managed stackable
switch. The terminal displays “running testing procedures”.
When the following dialog box in Figure 2 below appears,
type the factory default user name "
admin
" and password
“
admin
”.
User name:
admin
Password:
admin
Figure 2: Console login screen
Note:
1. For security purposes, change and memorize the new
password after this first setup.
2. Only commands in lowercase letters are accepted in the
console interface.
Configuring the IP address
The managed stackable switch is shipped with the default IP
address shown below:
IP Address:
192.168.0.100
Subnet Mask:
255.255.255.0
To check the current IP address or modify a new IP address
for the managed stackable switch, use the following
procedures:
Display of the current IP Address
1. At the “#” prompt, type “show ip interface brief”.
2. The screen displays the current IP address.
Figure 3: IP information screen
Configuration of the IP address
3. At the “#” prompt, type the following command and press
Enter as shown in Figure 5.
Switch#
configure terminal
Switch(config)#
interface vlan 1
Switch(config-if-vlan)#
ip address 192.168.0.100
255.255.255.0
The previous command would apply the following settings
for the stackable managed switch.
IP Address: 192.168.0.100
Subnet Mask: 255.255.255.0
Figure 4: Configuring the IP address screen
4. Repeat step 1 to check if the IP address has changed.
Store the current switch configuration
5. At the “
#
” prompt, type the following command and press
Enter.
# copy running-config startup-config
Figure 5: Saving current configuration command screen
If the IP is successfully configured, the managed stackable
switch applies the new IP address setting immediately. Access
the web interface of the stackable managed switch through the
new IP address.
Note
: If unfamiliar with the console command or the related
parameter, type “help” in the console to obtain the Help
description.
Starting web management
The section describes how to start up the web management
function for the stackable managed switch. Note that the
stackable managed switch is configured through an Ethernet
connection. Ensure that the manager computer is set to the
same IP subnet address.
For example, if the default IP address of the stackable
managed switch is 192.168.0.100, then the manager computer
should be set to 192.168.0.x (where x is a number between 1
and 254, except 100), and the default subnet mask is
255.255.255.0.
