3
UK
9.4.2 Set output status in fault condition ......................................................24
9.4.3 Set delay for the switching outputs .....................................................25
9.4.4 Set output logic for the switching outputs ...........................................25
9.4.5 Set damping for the switching signal ..................................................25
9.4.6 Set damping for the analogue signal ..................................................25
9.4.7 Calibrate curve of measured values ...................................................25
9.5.1 Read min/max values for the system pressure ..................................26
9.5.2 Reset all parameters to factory setting ...............................................26
9.6.1 Open menu level 3 (simulation) ..........................................................26
10.2 Change the display in the Run mode .......................................................28