Pour la programmation, effectuer les étapes suivantes dans l'ordre indiqué.
1
Accéder aux fonctions étendues
• Appuyer sur le bouton-poussoir Mode/Enter jusqu'à ce
que EF soit affiché.
• Appuyer sur le bouton-poussoir Set. Le premier
paramètre du menu étendu est maintenant affiché. En
appuyant encore une fois sur le bouton-poussoir Set vous
accédez à la valeur de paramètre correspondante. L'appui
sur le bouton-poussoir Mode/Enter donne accès aux
paramètres suivants.
2
Sélection de l'unité d'affichage
Choisir l'unité d'affichage :
cm
/
inch
.
Choisir l'unité d'affichage avant de régler les valeurs pour
les paramètres (
SPx, rPx, LEnG, OFS
). Cela évitera les
erreurs d'arrondi générées en interne lors de la conver-
sion des unités et permettra de régler des valeurs exactes.
Réglage en usine :
Uni = cm
.
3
Réglage de la longueur de sonde (length)
Le réglage n'est nécessaire que si la longueur de la sonde
est différente de celle d'origine.
A la livraison : LEnG = longueur de sonde L (voir schéma,
page 67).
• Déterminer la longueur de sonde réelle (mesurée à par-
tir du bord inférieur du filetage jusqu'à l'extrémité de la
sonde). Arrondir cette valeur à 5 mm / 0,2 inch.
• Activer le paramètre LEnG. Saisir la nouvelle valeur.
La plage de réglage pour la longueur de sonde est indi-
quée dans la table à la page 60.
4
Saisie de la valeur offset
La zone entre le fond de la cuve et le bord inférieur de la
sonde peut être saisie comme
valeur offset (OFS)
. De ce
fait, l'affichage et les seuils de commutation se réfèrent
au niveau réel. Réglage en usine :
OFS = 0.
Valeurs de réglage
pour
OFS
→
page 60.
Attention : Régler
OFS
avant de régler les seuils de com-
mutation (
SPx
,
rPx
) et
OP
. Il est ainsi possible d'éviter des
mauvais réglages par inadvertance.
58
Paramètre
Pas
Programmation