IFM DV15 Series, Руководство по эксплуатации

Страница: 14 / 22

14
8.2 Operation of the standard version
The unit is connected to the digital outputs of the controller via an 8-pole cable
(see accessories at www�ifm�com)� The 6 HTTL inputs of the signal lamp are
triggered with 24 V DC� According to the set parameters, the 5 LED segments are
on and the buzzer sounds (only with DVx510 and DVx530)�
The signal inputs can be triggered either in PNP or in NPN technology
(→ 6.2
Standard device (DV15x0))�
With the parameter setting button the following properties can be set for every
LED segment:
• Colour (red, green, orange, blue, violet, turquoise, white, yellow, off)
• Frequency (permanently on, low flash rate slow/medium/fast, high flash rate
slow/medium/fast)
• Brightness (100 %, 75 %, 50 %, 25 %)
Parameter setting via the IO-Link interface (pin 8 of the M12 connector) is also
possible�
After parameter setting, the unit goes to the Run mode�
8.3 Demo mode
In demo mode, the unit demonstrates the different
• colours
• visual indications of analogue values (styles)
• buzzer sounds (buzzer styles, provided the unit features a buzzer)
► Set the parameter [Demo mode] in the IO-Link parameter setting tool (e�g�
LR DEVICE)� For SIO and IO-Link mode, the demo is available in 3 different
speeds, respectively�
9 Parameter setting
9.1 IO-Link version
The unit can be configured using an IO-Link parameter setting tool (e�g� LR
DEVICE) (→ 3.1 IO-Link) �
More information is given in the IODD at www�ifm�com�