3-segment signal light
DV13x0 DV23x0
7
5 Installation
u
Disconnect the power of the machine before installation.
u
For installation choose a flat mounting surface.
1
18
40
M4
Fig. 1: Fixture (view from bottom)
1:
Front side
u
Attach the fixture for the unit to the mounting surface using the supplied M4 nuts. Tightening torque
1.8 Nm.
u
Only with the models DVx300 and DVx310:
For mounting on a horizontal surface attach the base to the fixture (overlapping marks on base and
fixture) and turn clockwise by approx. 10 ° to fix it. For mounting on a vertical surface loosen the
screw in the base, turn the upper part of the base by 180 ° and tighten the screw again. Attach the
base to the fixture (overlapping marks on base and fixture) and turn clockwise by approx. 10 ° to fix
it.
u
Insert the cable through the fixture and, if necessary, the base and connect the socket with the M12
connector in the signal lamp. Tightening torque max. 1 Nm. (Observe the maximum tightening
torque of the connection cable.)
u
Attach the signal lamp to the fixture or the base (overlapping marks) and turn clockwise by approx.
10 ° to fix it.
Integrated seals at the bottom of the fixture and in the base as well as O-rings at the fixture and
base prevent ingress of moisture.
Information about available accessories at www.ifm.com
GB