AE3100
IIoT controller
12
7 Electrical connection
7.1 General notices
The device must be connected by a qualified electrician.
u
Observe the national and international regulations for the installation of electrical equipment.
The device contains components that can be damaged or destroyed by electrostatic discharge.
u
Please observe the required precautions against electrostatic discharge!
7.2 Ethernet ports (IT level)
The device is connected to the IT network level via the ethernet ports eth0 and eth1.
Power-over-Ethernet (PoE) is not supported. The connection of PoE components is not permitted.
Wiring:
1
2
3
4
5
6
7
8
1: TX +
5: Not used
2: TX -
6: RX -
3: RX +
7: Not used
4: Not used
8: Not used
u
Connect the device to the IT network via a free Ethernet port.
u
Optional: Connect the device with another device via a free Ethernet port.
u
Use an RJ45 connector for the connection.
7.3 Ethernet ports (OT level)
The device is connected to the OT level via the eth2 and eth3 Ethernet ports.
Power-over-Ethernet (PoE) is not supported. The connection of PoE components is not permitted.
Wiring:
1
2
3
4
5
6
7
8
1: TX +
5: Not used
2: TX -
6: RX -
3: RX +
7: Not used
4: Not used
8: Not used
u
Connect the device to the OT network via a free Ethernet port.
u
Use an RJ45 connector for the connection.
7.4 USB ports
Additional USB devices can be connected with the device via ports usb0 and usb1.
Note the supported device types
!
The USB ports have overload protection.
The USB ports have short circuit protection.
Maximum cable length per port: 3 m
Available sum currents on both USB ports for the supply of the connected devices: max. 1.5 A
Wiring:
