IO-Link master with EtherCAT interface DataLine 4 ports IP 65 / IP 66 / IP 67
22
8
Set-up
52811
When the supply voltage is switched on, the AL1330 starts with the factory settings. The display
elements signal the current operating mode (
→
Operating and display elements
(
)).
To enable parameter setting of the AL1330, the IoT interface and / or the fieldbus interface must be
configured according to the network environment.
► Configure fieldbus interface (→
Fieldbus: Configuring the fieldbus interface
(
Integrate the IO-Link master into the TwinCAT project
)).
► Configure IoT interface (LR DEVICE: →
IoT: Configure IP settings
(
) or
→
IoT:
Configuring IP settings
(
>
IoT / fieldbus interface has valid settings.
>
User can set the parameters of the AL1330.
Further steps:
•
Optional: Update firmware of AL1330 (
→
Updating the firmware
(
)).
•
Set the parameters of the AL1330 (
→
Configuration
(
)).