11
UK
8.2 Menu explanation
SP1/rP1
Maximum / minimum value for system pressure, at which output 1 changes
its switching status�
OU1
Output function for OUT1:
•
Switching signal for the limit values: hysteresis function [H ��] or window
function [F ��], normally open [� no] or normally closed [� nc] each�
•
Diagnostic signal [dESI]�
SP2/rP2
Maximum / minimum value for system pressure, at which output 2 changes
its switching status�
OU2
Output function for OUT2:
•
Switching signal for the limit values: hysteresis function [H ��] or window
function [F ��], normally open [� no] or normally closed [� nc] each�
tCOF
Teaching zero-point calibration�
EF
Extended functions / Opening menu level 2�
Uni Standard unit of measurement for the system pressure�
SELd
Display mode:
•
Pressure in the unit set in [Uni]�
•
Pressure in percentage value (% of the span)�
HI Maximum value memory for the system pressure�
LO Minimum value memory for the system pressure�
COF Zero point calibration�
dS1/dS2 Switch-on delay for OUT1/OUT2�
dr1/dr2 Reset delay for OUT1/OUT2�
P-n Output polarity: pnp / npn
dAP Damping for the switching outputs�
diS Update rate and orientation of the display�
rES Restore the factory setting�
