IFM Electronic PI7093, Руководство по эксплуатации

Страница: 16 / 21

16
9.4.4 Setting the damping for the switching outputs
► Select [dAP] and set value between 0�1 and 100�0 s (at 0�0 = [dAP] is
not active)�
dAP value = response time between pressure change and change of the
switching status in seconds�
[dAP] influences the switching frequency: f
max
= 1 ÷ 2dAP�
[dAP] also affects the display�
9.5 Service functions
9.5.1 Reading the min./max. values for the system pressure
► Select [HI] or [LO], press [Set] briefly�
[HI] = maximum value, [LO] = minimum value�
Delete memory:
► Select [HI] or [LO]�
► Press [SET] until [----] is displayed�
► Press [MODE/ENTER] briefly�
9.5.2 Reset all parameters to the factory setting
► Select [rES]
► Press [SET] until [----] is displayed�
► Press [MODE/ENTER] briefly�
It makes sense to note down your own settings before executing the func-
tion (→ 13 Factory preset).
10 Operation
After power on of the supply voltage the unit is in the Run mode (= normal operati-
on)� It carries out its measurement and evaluation functions and generates output
signals according to the set parameters�
Operating indicators → chapter 7 Operating and display elements.
10.1 Read the set parameter values
► Press [Mode/Enter] until the requested parameter is displayed�
► Press [Set] briefly�
> The unit displays the corresponding parameter value for about 15 s� After
another 15 s the unit returns to the Run mode�