IFM Electronic DTE800, Руководство по эксплуатации

Страница: 20 / 37

20
7 Operating the reader
7.1 Communication
The [Communication] tab groups together all the functions for establishing connections and configuring
the interface cards�
When the connection is established, the program interrogates the information about the installed I/O
cards� The information can be viewed and changed via the I/O card configuration�
Figure: Tab for the Communication by Ethernet I/O card
7.1.1 Ethernet header
The Ethernet connection can be achieved by linking the reader into an existing network, or by a direct
connection between the reader and a control computer� For direct connection of the reader to the PC, a
cross-link cable is required, unless the LAN interface on the PC supports “auto-mdi-x”� Alternatively two
standard patch cables and a switch can be used�
Network settings
The IP address range of the device and the PC have to match�
IP address range Factory setting
RFID UHF Reader 192�168�0� 1
= ≠
PC 192�168�0� x (e�g�: "2")
Note
From reader firmware 2�04, the reader in the ex-works condition has the IP address 192�168�0�1 with the
network mask 255�255�255�0� Reader versions earlier than this are configured for DHCP�
Verifying and setting the IP address PC
Activate the menu "Internet protocol (TCP/IP) Properties"�