IFM Electronic CR3150, Руководство по эксплуатации

Страница: 12 / 23

CR3150 mobileIoT gateway
12
4.7 Energy management
Different energy modes control the energy consumption of the unit. In addition to the standard mode,
the unit also features a sleep mode. In this mode, some functions are deactivated to save energy.
Specific events cause the unit to return to the standard mode.
No mobile radio connection is possible in sleep mode.
Energy management is accessed via the following objects:
Object Index Subindex Type Default Description
Power manage-
ment – deep
sleep flag 0x3333 0xF3 U8
wo — If this flag is set, the unit can only be woken
up from sleep mode via clamp 30, clamp 15
or CAN1.
The unit will not make up from sleep mode
cyclically or on a vibration event.
Use e.g. during transport
u Set this flag before changing to sleep
mode.
Power manage-
ment – time to
sleep 0x3333 0x08 U8
wo — Time in seconds until switching to sleep
mode.
The unit only changes to sleep mode if
clamp 15 is set to low and no CAN message
is present at the corresponding CAN inter-
face.
A CAN message can wake the unit from
sleep mode.
Depending on the device design, a level
change at clamp 15 or the detection of a
certain acceleration force can wake the unit
from sleep mode.
With this setting, CAN messages are sent if
clamp 15 is set to high.
Power manage-
ment – sleep tim-
er status 0x3333 0x29 U8
ro — 0: sleep timer deactivated
1: sleep timer activated
The object can be read if clamp 15 is set to
high.
Power manage-
ment – shutdown
delay time 0x3333 0x32 U16
rw — Delay time in seconds
After detecting the ignition input (clamp 15)
and the CAN off state, the unit continues to
operate for the specified time and then goes
to sleep mode.
Power manage-
ment – cyclic
wake-up time 0x3333 0x35 U32
rw — Time in seconds
After the specified time period in sleep
mode, the unit automatically wakes up and
changes to standard mode.
This function is only active with a value > 0.
Power manage-
ment – accel.
wake-up force 0x3333 0x36 R32
rw — Force in g
If the accelerometer detects an acceleration
force greater than this value, the unit wakes
up and changes to standard mode.
This function is only active with a value > 0.
Power manage-
ment - CAN
sleep time 0x3333 0x41 U32
rw — Time in milliseconds
If the unit does not receive any CAN mes-
sages within the specified time period, it
changes to sleep mode.
This function is only active with a value > 0.
4.8 Device status
The unit can send this data via the CAN interface. The configuration is made via the following objects: