For installation and set-up follow the instructions on the use in
hazardous areas.
Function and features
The AS-i AirBox is a slave in the AS-i system (AS-i profile S 7.F). It is the
connection between the two dual sensors, the two pneumatic outputs
and the AS-i master.
• Operating voltage 26.5...31.6V DC
• Current consumption < 170mA
• Total current load for all inputs 100mA
• Plug-in sensor connection
• AS-i connection via EMS module lower part
• Connection to pneumatic system via push fit tube connector Legris
3000/8mm, outside calibration according to CETOP standard RP 54 P
• Operation with compressed air of 2...8bar including any pressure
peaks (Pressure peaks >8bar can cause permanent leaks and irrepa-
rable damage of the AirBox).
Mounting
Address assignment by means of the addressing unit.
Fix the module onto the addressing unit. Assign a free address between
1 and 31;
the factory preset is 0
.
6
I-1/2
I-3/4
I-1
I-3
I-4, O-4
I-2, AS-i PWR, O-3
exhaust 3 [R]
compressed air 1 [R]
pneumatic
outputs O-3/O-4
manual override 2 for O-4
flat cable yellow
label
manual override 1 for O-3
