iflo Thirle Electric Shower 8.5 Kw, Инструкции по установке и Руководство пользователя

Страница: 17 / 24

16 17
Commissioning - Testing the System
Warning: Before using the shower for the first time,
it should receive a final flush through to remove any
remaining debris that may be in the pipe work or hose
and to ensure the heater unit contains water before the
electrical elements are switched on.
Remove the showerhead from the hose and if not already
attached, attach the hose to the outlet port and ensure that
the outlet hose mesh filter is fitted.
The power control knob (2) must be switched to the cold
( - 9’oclock) position ‘blue’ (heating elements will not
be on).
The temperature control knob (3) must be set fully
clockwise to minimum flow. (This is to prevent the PRD
activating when water is first turned on).
Turn on the water supply and inspect for water tightness.
Turn on the mains electrical supply to the shower.
Press the STOP/START button (1), wait approximately 30
seconds for the water to flow correctly. Once the water
has flowed for a further 10 seconds, rotate the temperature
control knob (3) from the fully clockwise position to the fully
anti-clockwise position. Repeat this procedure several times
until a continuous flow of water (with no air bubbles) is
obtained from the shower hose.
Once you are satisfied that the system has been flushed
through thoroughly, press the STOP/START button (1) to
stop the flow.
Note: If the letters LP appear on the front
panel just above the STOP/START button (1)
this indicates too low a water supply pressure
to the unit. Please switch off unit until water
pressure increases before continuing to use
the shower.
Re-fit the showerhead to the hose, insert hose rubber
washer to seal the joint; please ensure that the hose passes
through the larger hole in the soap dish. The showerhead is
attached to the riser rail by inserting the conical hose end
into the movable slider.
Your shower is now ready for first use.
Need help?
For further technical help or advice please contact your point of purchase.
eco
eco
2
3
1