10
motion detection Show Message on the monitor.
Black detect: Alarm Output and Show Message can also be chosen when the screen on the channel is
black because of light, etc.
In Region, move cursor to Set, then press ENTER. The setting area has been divided into 192 sections.
Green section means the current cursor position, and black section is
the armed motion detection area. The blue area is disarmed motion
detection area. Press Fn to toggle between armed mode and
disarmed mode. When in armed mode, you can press the arrow keys
to cover the MD region. After the setting, press ENTER to confirm or
ESC to cancel. Before you exit DETECT, you must press Save to save
the setting.
Prompt: You can use mouse dragging to select motion detection region without Fn key. Right click to
exit the region, then click Save to save the setting. Copy and Paste can be used for the same setting
between different channels.
2.2.4 Alarm Recording
·See MAIN MENU>SEETING>ALARM
Connect alarm sensors to the alarm input
port according to the related instruction of
Chapter 2
·Connect the related alarm output(such as
light, buzzer, etc.)
Alarm Channel Select the related channel
（
1-16
）
. Type has Normal Open /Normal
Close voltage output modes. Start Record
select the recording channels when there is
alarm input (Can choose more than one
channel). Alarm Output Choose alarm
output ports when there is an alarm input. The first and second ports will trigger corresponding relay.
The third port output controllable 12 voltage. Delay means to extend the recording time after
receiving disarmed signal(10
、
20
、
30
、
……90SEC). When the outside alarm is disarmed, the system
will extend the recording time automatically before closing alarm relay output.
Show message Highlight means display the message for alarm output in the monitor.
