Screw hole
Low duct cover
Screw hole
Low duct cover
Low duct cover hook
M4 Screw
Step 2:
Fix the low duct cover hook to the low duct
cover with 2pc M4 screws.
Step 3:
Put the low duct cover to the body, and use
two M4x10 screwsto fix the low duct cover
to the body.
11
5
Back of the chimney
A
B
Expanding Tube
5x60
Expanding Screw
Step 5:
According the space between the hole A&B ,
drill 2 holes in level on the wall with 8mm in
diameter and 60-70mm in depth. Press the 2
expanding tube into the holes. Tighten the 2
expanding screws of 5x60mm to the expanding
tube.Make sure it is fixed firm and cannot be
move.Hang the chimney on the 2 expanding
screws ensure the chimney is level and
vertical.
Step 4:
Put the chimney on the wall and mark
the position where you want to install.We
recommend the height from the hob to the
lower edge of the chimney should be from
650mm-750mm.
16
Accessory shown in the picture(remote) is not a standard part of the product.
A
C
B
C
D
E
Remove control
A: Touch “A” to set the standby mode or power off.
B: Touch “B” to turn on /turn off the cleaning mode.
C: Touch “C” to open or close time delay mode(3min
/6min / 9min).
D: Touch “D” to open or close the LED lamp.
E: Touch “E”, the cooker hood would starting at the
High speed, every time your touch can change the
speed level, form high speed to low speed, total have 6
different speed level. Circulate by this way, If you
touch it for sixth time, the fan function would be
closed.
LAMP
TIME
FAN
POWER
LCD
LIGHT: touch “ ” to open or close the LED lamp.
TIMER: Only when the motor is running, touch “ ”once, to enter in
time delay mode. under time delay mode, keep touch “ ”request
delay, your every touch can add 3 mins (MAX 9mins delay).
Kindly remind : Pls make sure operation in 1min after enter in time
delay mode or the machine will exit the delay status.
FAN: In standby mode, when you touch “ ” ,the cooker hood would
starting at the High speed ,you can touch “ ”to increase the speed or
touch “ ”to reduce the speed, total have 6 different speed level.
POWER: Touch “ ” once then enter in standby mode , you can start
operation. If touch “ ” when the motor is running , then machine
will be Automatic off after 60 seconds. Or you can touch “ ” twice ,
to stop all operations immediately.
