Http://www.ifarsys.com
Mobile DVR Manual V6.0
20
Record upon Power ON start recording (default)/Timed Recording/Alarm Recording,
press [ENTER] to input.
There are 3 modes: Power ON Startup, Timed and Alarm, and the default mode is
Power on start recodding
ON
: Automatically starts recording at startup of the device
Timed
: Automatically starts recording at the set time
Alarm
: When there is alarm event triggered alarm recording
IQ(image quality)
Grade 1 to grade 8 for selection (1 is the best)
RS(Resolution)
720P/D1/HD1/CIF, D1 by default, press [ENTER] to input.
Audio
To set whether to encode audio synchronously while video recording or not. Select
enable/ disable, and press [ENTER] to input.
Time Slice
Length of each section of video recorded in continuous recording status, 15/30/45/60,
[ENTER] to input.
SD Function
(*Future add)
No recording / Mirror image recording / Record upon loss, press [ENTER] to input.
1) No recording: recording is only available for hard drive, even if it’s full, the SD
card will not be used for recording.
2) Mirror image recording: When the hard drive is recording video with the main
stream, the SD card is recording video with the sub-bit stream; When the hard
drive is not recording, the SD card will not record; the recording will not be started
without the SD card; and the recording with SD card will not be started without the
hard drive;
3) Record upon loss: in case hard drive error or absence of the hard drive, the SD
card will record video with the main stream;
Note: If both the hard drive and the SD card exist, priority should be given to the hard
drive.
Video channel settings
This is used for setting recording parameters of each channel, press [ENTER] to
input.
4 channels, image quality levels from 1~8, with level 1 as the highest and level 8 as
the lowest, frame rate: 1~25 frames for PAL and 1~30 frames for NTSC; recording can
be enabled or disabled.
REC Delay for alarm recording
10 seconds by default, adjustable within the range 1 seconds~999 seconds, press
numeric keys to input.
VM (Video signal input)
Standard/High/Mixture.
Standard is Analog video input. High is 4 channel AHD 720P input. Mixture channel