Ier 506, Руководство пользователя

Страница: 20 / 44

20
6) Loading Roll Media
a) Preliminary Steps (Roll Media Shaft with Removable
Flange):
Refer to the Figure of Page 21.
•
Remove flange (1) from shaft (2).
•
When installing the media roll (3) on shaft (2), make sure that
the heat-sensitive side (4) of the leading document will be
facing up when inserted into the printer.
•
Slide the core of roll (3) onto the hubs (5). Power up the
printer (see Page 14).
b) Preliminary Steps (Roll Media Shaft with Retaining Pin):
•
Slide the core of roll (3) onto the roll media shaft (8) while
making sure that the heat-sensitive side (4) of the leading
document will be facing up when inserted into the printer (see
Page 22).
c) Automatic Media Loading:
•
Insert the leading document of the roll media into the insertion
slot (7) (see Page 21). It will be drawn in automatically.
•
The document is automatically ejected, after some possible
forth and back movements, which correspond to the
separation mark self-calibration phase. Install flange (1) by
setting it against roll (3).
d) Manual Media Loading (Requires Lifting of the Printhead):
•
Push the printhead lever (6) up and insert the leading
document (4) of the roll media into the insertion slot (7). Push
it in until it protrudes from the ejection slot.
•
Lower the printhead lever (6). The document is automatically
ejected, after some possible back and forth movements,
which correspond to the separation mark self-calibration
phase.
•
Install flange (1) by setting it against roll (3).
IMPORTANT:
Should media insertion into the rear feed slot be difficult,
perform the paper path adjustment again (see Page 16). Also
check that the roll is correctly aligned with the paper path. If
not, perform media roll position adjustments.