IEMCA SIR52 MS52 P, Руководство по эксплуатации и техническому обслуживанию

Страница: 94 / 212

EN
6 - USE AND OPERATION SIR 52 MS52 P/F
6 - Pag. 22 / 30
31 Press key to close the truck-bar pusher locking device; LED of sensor S4 has to be
on. Otherwise, open locking device again, longitudinally move the bar pusher of some
millimetres and close locking device again.
32 Press key to open the guides.
33 Press
key to rotate the clamp arm towards the drum.
34 Press key to close the guides.
35 Press key to open the truck-bar pusher locking device.
36 Press key to bring the remnant into the lathe collet.
37 Press key to make the clamp arm rotate outside the drum.
38 Give the lathe the order to make one spindle station rotate and stop it at zero point. Press
key and repeat from step 15 to step 37.
39 Repeat step 38 until all bar pushers are replaced.
40 Remove all bars left from the magazine.
41 Prepare the new bars (paragraph 6.5.).
42 Load bars (paragraph 6.6.).
43 Adjust magazine (paragraph 5.1. and 5.2.).
44 Bring magazine control selector switch S 106 to position "1".
45 Press
key .