Print More Materials, All For Application
32
6.8 Print Head Disassembly and Maintenance
Attention: Please disassemble and install the print
head with the power off
The equipment is a dual Quick Detachable Print
Head, if the print head needs to be replaced during
use, the steps are as follows.
Step 1: Check whether there are supplies in the
print head if there are supplies first remove the
supplies (refer to Printing - Loading and Unloading
Supplies for details).
Step 2: Turn off the power and loosen the three
screws as shown in the figure.
Step 3: Pull out the print head, press the
pneumatic interface black rubber to pull out the feed
tube, complete the removal.
To replace the print head, proceed as follows:
Step 1: Install the print head in the original
position, tighten the front two screws so that the print
head is closely connected to the base, and then tighten
the side screws.
Step 2: Check the installation effect, open the tool -
preheat, if the display temperature is "1023", that the
print head is not installed correctly or the print head is
damaged.
Steps to disassemble the nozzle
Unscrew the 2 screws Unscrew the 2 screws Loosen the 2 Screw
Unscrew the 2 screws Disassembly complete
