I
E
M
I N D U S T R I A L E Q U I P M E N T A N D M A C H I N E R Y G M B H
Tel. +49(0)6131/914694 • Fax +49(0)6131/963109
E-Mail:
• Web Shop:
http://www.waterpilot.de
• internet:
www.iemgmbh.de
Preparations before the Installation
1. The Unit can operate horizontal as well as in vertical Position. We recommend the vertical Installation
because of the easier Way to change the Filters. Please be sure to have enough Space for the Replacement
of the Filters. At the same Time the Unit should be installed near the Water Supply to avoid Pressure Drops
through short Pipes.
2. The Tank should be positioned, where it doesn´t displace. It doesn´t need to be fixed and can be displaced
later, if necessary.
3. The Tap should be positioned, so that the Water can drain into a Sink. When Mounting, please be sure, that
there is enough Space for the Faucet.
Mounting of the Faucet
1. For the Faucet you need a Boring of Ø12mm. For Stainless Steel Sinks we recommend a Tapered Drill (No.
11802/3-14mm).
2. For wooden Counter Tops up to 25mm Thickness, you can use a Wood- or Metal Drill.
3. For wooden Counter Tops up to 40 mm Thickness, you need to countersink min. 15mm from the Bottom,
using a Fortner-Drill (Ø40mm- No. 79510/40mm). Drill with a small Borer from the Bottom to the Top and
afterwards rebore the Hole from the Top, using a 12mm Drill.
4. To tighten the Armature you need a 14mm Für das Festziehen der Armatur (Einbauhahn) benötigen Sie
einen 14mm Socket Wrench (Nr. 62010/14x15). Please position the Plates and Seals as shown below and
tighten the Nut.
Installation of the des Water Connection
*** Please be sure, that the Water is shut off, before working on the Water Pipe Net. ***
For the Water Connection, we enclosed two Parts:
§
Feed Water Connector (A130) with ½” Inner- and ½” Outer Thread, with ¼” Inner Thread for the
Connection of the Ball Valve (A200)
§
Ball Valve (A200) with 1/4“ Inner– and Outer Thread
Feed Water Connector (A130)
Ball Valve (A200)
