IEK UNIVERSAL Series, Руководство по эксплуатации

Страница: 23 / 28

2 3
Replacing the battery and fuse
If the display indicates the symbol " ", you must replace the battery.
To replace the battery, remove the screws on the back cover, open the casing.
Remove the dead battery and install a new one as per the specs: 9 V
"KRONA" type (NEDA 1604, 6F22). Replace the back cover, tighten the screws.
ATTENTION!
– Before opening the back cover of the multimeter, make sure that the
multimeter is off and the probes are disconnected from the tested devices.
– When installing a new battery observe the correct polarity.
– The fuse goes down only in the event of a heavy and prolonged overloading
of the device due to the erroneous selection of measuring ranges.
To replace the fuse remove the back cover of the multimeter as and when
you replace the batteries. Replace the fuse by a new one of the type: 500 mA/
250
V. Close the casing.
ATTENTION!
To prevent the risk of fire, use fuses with current/voltage
values similar to the values of the current/voltage of the fuse installed at the
factory.
Disposal
Multimeters shall not be disposed as household waste. In order to dispose
handle the device to a specialized company for recycling in accordance with the
legislation of the Russian Federation.
Remove the battery before disposal of the device. You can deliver the
batteries to the specialized collection points responsible for collection of this type
of waste, at the place of residence.
Conditions of transportation and storage
Transportation of multimeters is allowed by any kind of enclosed transport
ensuring protection of packaged multimeters from mechanical damage, dirt, and
moisture.
Transportation of multimeters with regard to the influence of mechanical
factors is to be carried out at a temperature from -10 to + 35
°
C.
Storage of multimeters is to be carried out in the manufacturer's package in
rooms with natural ventilation at an ambient temperature from -10 to + 45
°
C and
relative humidity not more than 80 %.