IEI Technology WSB-Q354, Руководство пользователя

Страница: 85 / 205

WSB-Q354 PICMG 1.0 CPU Card
Page 70
Before the WSB-Q354 is installed in the system, the jumpers must be set in accordance
with the desired configuration. The jumper on the WSB-Q354 is listed in Table 5-1 .
Description Label Type
Clear CMOS J_CMOS1 3-pin header
Table 5-1: Jumpers
5.5.1 Clear CMOS Jumper
Jumper Label:
J_CMOS1
Jumper Type:
3-pin header
Jumper Settings:
See Table 5-2
Jumper Location:
See Figure 5-9
If the WSB-Q354 fails to boot due to improper BIOS settings, the clear CMOS jumper
clears the CMOS data and resets the system BIOS information. To do this, use the jumper
cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1
and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in Table 5-2 .