IEI Technology SRM-KIT Series, Руководство пользователя

Страница: 55 / 77

SRM-KIT Series LCD Monitor
Soft working mat
: When the SRM-KIT series industrial monitor is installed,
the screen is placed on the working surface. It is therefore important to rest
the MPC industrial workstation on a soft at that cannot damage the LCD
screen on the front of the SRM-KIT series industrial monitor.
4.3.2 Voltage Select Jumper Settings
If the monitor comes with both 12V and 9 ~ 36V DC power connectors, the voltage select
jumper on the integrated AD board must be configured for the DC connector that is used
to power the monitor. Refer to
Section 3.3.2
for the appropriate jumper settings of the AD
board.
NOTE:
The default voltage select jumper is configured for a 12V power source.
Do not change the jumper setting unless a 9~36V DC power connector
is to be used as the monitor’s power source.
To properly set the voltage select jumper, the following steps must be completed:
Step 1:
Use a screwdriver to remove all the screws holding the rear panel to the monitor.
Step 2:
Remove the rear panel.
Step 3:
Locate the voltage select jumper. (See
Section 3.3.2
)
Step 4:
Use the jumper(s) to set the correct voltage input. (See
Section 3.3.2
) Replace
the rear panel.
Step 5:
Replace all removed screws.
Step 0:
4.4 Connectors
Table 4-1
lists the external peripheral interface panel connectors for the SRM-KIT series
industrial monitors.
Page 41