IEI Technology NANO-GM45A, Руководство пользователя, Страница: 56 / 128

NANO-GM45A EPIC SBC
Page 44
Figure 4-4: SO-DIMM Installation
Step 1: Locate the SO-DIMM socket . Place the board on an anti-static mat.
Step 2: Align the SO-DIMM with the socket . Align the notch on the memory with the
notch on the memory socket.
Step 3: Insert the SO-DIMM . Push the memory in at a 20º angle. (See Figure 4-4 )
Step 4: Seat the SO-DIMM . Gently push downwards and the arms clip into place. (See
Figure 4-4 ) Step 0:
4.5 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
Figure 4-5: Jumper Locations
Before the NANO-GM45A is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the NANO-GM45A are listed in
5
Table 4-1 .