6
1. S lide the inside lower housing over the lever tube until it has
passed over the lever catch. Make sure no wires are
pinched by the lower housing.
2. F asten with two brass #8 screws. Once secure, fasten the
finished #8 screw at the bottom.
3. R emove red strip form battery pack to power the unit before
continuing.
B rass #8 S crews
F inished #8
Inside Lower Housing
Lever C atch
B attery C over
#8 S crews
Inside Lower
Housing
C enter
G rooved S tud
1. Attach the battery cover with two finished #8 screws.
B attery cover has a lip which engages the lower inside
housing, it is important that this lip be seated properly to
insure correct alignment.
1. Insert cylinder retainer into lever until flush with base of lever.
2. P ush lever on door in horizontal position until secure.
R emove red strip
to engage battery pack
I n s ta l l i n g I n te r i o r A s s e m b l y
( p a r t 2 )
F igure 9
F igure 10
A
A
Lower Housing
B
Battery Cover
C
Interior Lever
Interior Lever
C ylinder
R etainer
Electrical
Symptom
Probable Cause
Correction
1. B eeping after as s emby is completed
(4 long beeps )
Low V oltage
R eplace B atteries
2. S olid green LE D, no motor action
C ontrol Module not s ending lock/unlock puls e
V erify continuity of wire harnes s and
replace if neces s ary
3. Y ellow LE D flas hes and s ounder chirps
after ins tall
Unit not intialized
C ontact IE I
4. Motor locks but will not unlock
5. Unable to change s ys tem default
R E X loop is s horted
(B rown and Orange on P 4 wire harnes s )
Ins pect connection and remove s hort
V arious
C ontact IE I
Mechanical
Symptom
Probable Cause
Correction
1. Lever S ticks or is s luggis h
Hand is too clos e to front es cutcheon
T ighten motor s pacer ring
2. Handle res ts in down pos ition
B us hing is not s et correctly
R emove handle and s et bus hing in es cutcheon
3. C annot s nap on handle
A. C has s is not adjus ted correctly
B . C has s is lever locking tab is damaged or mis s ing
A. Adjus t to correct s etting
B . C ontact IE I
4. C annot tighten the raceway by hand
5. Latch works in only one direction
R ace threads are damaged
Us e thread chas er to clean threads or contact IE I
T he backs et is not centered on the latch retractor
C enter the backs et on the latch retractor
TROUBLESHOOTING
4 of 6
F C C Label
7
6. Does not read proximity cards
Unit may not be an LS -2P
C heck the F C C Label (s ee F igure 10). If the label does not refer
to model LS -2P then it is an LS -2 and not an LS -2P .
