IEI Technology IVS-200-ULT2, Руководство пользователя

Страница: 44 / 116

IVS-200-ULT2 Embedded System
Page 32
Figure 3-24: Mounting Bracket Retention Screws
Step 5:
Drill holes in the intended installation surface.
Step 6:
Align the mounting holes in the sides of the mounting brackets with the predrilled
holes in the mounting surface.
Step 7:
Insert four retention screws, two in each bracket, to secure the system to the
wall.
Step 0:
3.11.2 Mounting with VESA Mount Kit (Optional)
To mount the embedded system onto a wall using the optional VESA MIS-D 100 wall
mount kit, please follow the steps below.
Step 1:
Select the location on the wall for the wall-mounting bracket.
Step 2:
Carefully mark the locations of the four bracket screw holes on the wall.
Step 3:
Drill four pilot holes at the marked locations on the wall for the bracket retention
screws.
Step 4:
Align the wall-mounting bracket screw holes with the pilot holes.
Step 5:
Secure the mounting-bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them (
64
Figure 3-25
).