IEI Technology iSDV-200CTR, Руководство пользователя

Страница: 27 / 62

iSDV-200CTR
Page 19
3.5 Power-On Procedure
WARNING:
Make sure a power supply with the correct input voltage is being fed into
the system. Incorrect voltages applied to the system may cause damage to
the internal electronic components and may also cause injury to the user.
To power-on the iSDV-200CTR, please follow the steps below.
Step 1: Connect the power source to the power input jack on the rear panel.
Step 2: Once turned on, the power LED indicator on the front panel should turn on in
blue. Step 0:
3.6 Reset the System
The reset button enables user to reload factory firmware settings. The reset button
location is shown in Figure 3-7 .
To restore factory default settings, follow the steps below:
Step 1: Remove power from the iSDV-200CTR.
Step 2: Press and hold the reset button. While holding, plug power back into the
iSDV-200CTR.
Step 3: The LEDs on the front panel will blink (except video) for about 5-10 seconds.
When the LEDs stop blinking release the reset button.
Step 4: The iSDV-200CTR completes its boot-up process and restoring the factory
default settings.